Hi all,
Apologies this isn’t discus talk but not sure where to post.
Doing a water change last night I accidentally overfilled the tank and the stand took some water.
It’s the front of two of the vertical boards. Stand has the two outer and two inner and it’s the two on the right that have it. Looks like it’s made from MDF. Has bulged maybe a millimetre either side and probably only a couple of millimetres deep if that and probably goes 4 inches up. Also the horizontal piece the tank sits on has bulged on the top but this isn’t even a millimetre and couldn’t travel into the board because the tank is on top.
It seems minimal BUT it’s a 350 little tank. If it was smaller I wouldn’t worry. Anyone with any advice?
Would post picks but no idea how as I’m on mobile.