I can't show the backs because they are against the wall, but here are some side views...
Printable View
I can't show the backs because they are against the wall, but here are some side views...
...
i taped it up,triple taping, not leaving any air circulation and noticed that one end of my tank was dripping. i took the taping off and notice no more dripping. Now i just tape it enough to make it tight against the walls of the tank, taping it every feet in lenght.
any ideas for a clear tank cover that would let light shine through but keep heat and humidity in better than glass?
All I know is acryllic is a better insulator than glass :confused: On my tanks that don't have hoods, I use the standard 1/2" foam board as a hood and I cut a hole slightly smaller than the light and just rest the light on the foam board...
would the acrylic have to be fairly thick to prevent it from flexing? I've used polycarbonate, too expensive in my area.
what about styrofoam? would that do the same trick?
I mean some people paint the tanks white for breeding, and now you get the white from the styrofoam and the insulation all in one package.
Maybe just "glue" it on with some silicone or somthing.
Awesome thread, I will be doing this this winter!
Guys,
Will the Reflectix scare the discus when tank light is turn on?
It's easy to insulate the front, back, sides and the bottom of a tank, but... As the hot water or hot air tends to go up, one can expect major losses going over the top of tank. Has anyone considered insulated cover of his tank? Yes, it is obvious it is necessary to take into account some air exchange, lightning, easy access for feeding and a little maintenance etc., but I'm looking for anyone who successfully completed an insulation of a tank cover.