I connected mine with 22mm push fit connectors. I did 2 connections, the lower one with a right angle pipe in one barrel. I put the air supply in this pipe so that the water circulates between the two.
water barrel 01.jpg
water barrel 02.jpg
Well, it's been a long time since I posted on Simply! We moved from Virginia to Maryland (gonna have to change my handle) (Al, can I do that without losing the link to all my previous posts?), smaller house, downsized. So I couldn't bring my 200 gallon water storage tank with me. I picked up two 55-gallon drums on eBay ($50) used by a fire chief for drinking water, and put them in the basement shower. Now, I have to plumb them.
I can tap into the shower head for supply, but I'll need to cut a larger hole in the top of one barrel for the float valve. And I'll need to connect the two barrels at the bottom so that they fill and drain simultaneously. Finally, I'll have to put a submersible pump in one of them to pump water up to my 150 gallon tank in the living room.
Any recommendations for connecting the barrels? For putting some type of hole and cover in the top of one, or both barrels?
-Don
I connected mine with 22mm push fit connectors. I did 2 connections, the lower one with a right angle pipe in one barrel. I put the air supply in this pipe so that the water circulates between the two.
My old setup was exactly like yours. The barrels rested on a 2x4 platform, and they were connected from the bottom with Uniseals and PVC. You could also do it through the side and use a couple elbows inside the barrel to make sure the water is pulled within a 1/2" of the bottom. For the tops, I cut out the entire top with a reciprocating saw and traced along the outside edge. This left a bit of a lip for a lid (styrofoam and later greenhouse roofing) to rest on. Could also reuse the original top and zip-tie a dowel to it.
The first minute of this video explains it better https://www.youtube.com/watch?v=Yz66eO79wBE.
'
Good point about the air. Not sure, but I'd assume the pressure of the water would force the water level to equalize.
Gonna have to be quick showers, Don!
Willie
At my age, everything is irritating.
somewhere i saw people connect multiple barrels with large bulkheads.
i cut the tops off of mine, and didn't put it back on.
Don,
I just plumbed my 55's with 1'' UniSeals from bulk reef supply. Works fantastic, Uniseals conform to the rounded shape of the barrels. I have no issues with filling and draining they equalize at the same rate. I connected them about 3'' from the bottom. As for the tops, I cut out a square panel out and reconnected it with some stainless hinges as to make a little door to access the pump.
Picture is upside down f.y.i
Last edited by Debow; 08-14-2017 at 07:54 AM.