Awesome shaun, thanks so much man.
Sent from my PC36100 using Tapatalk
Awesome shaun, thanks so much man.
Sent from my PC36100 using Tapatalk
-Zach
No prob, your welcome.
Does your float valve have a adjustable wing nut on it so the float height can be adjusted ?
If so mine is about 4.5 inches from the top.
Oh and make the hole as small as possible so you really have to work it in there because the wall is so thin that the float will want to move on ya.
Last edited by Sean Buehrle; 10-06-2011 at 10:00 PM.
I'm not sure, it was supposed to be here today and idk what happened. Should tomorrow though. I have to drain tank in am and put what water I do have inside then run it all day and when off work add that water to tank. 75g tank with only 32g storage I only want to have a bout 10-15 gallons tap mixed in.
Sent from my PC36100 using Tapatalk
-Zach
Last edited by Sean Buehrle; 10-06-2011 at 10:27 PM.
If the float valve is by Kent Marine, it's slightly adjustable. I have float valve installed in my 44gal brute. I can get you the height from top of where to drill the hole if you want.
Van
Got it all setup and working guys thanks for the help.
Sent from my PC36100 using Tapatalk
-Zach
If my Di resin is completely gone should I remove it or not. Will it make a difference
Sent from my PC36100 using Tapatalk
-Zach
take it off.....don't look back!
Jim
Yeah you don't need a DI unit.
Think about it, your adding tap back to your ro water to raise the tds.
Only reason you would need a DI Unit would be if you were adding your own additives to raise tds.
Glad ya got it goin.
Ok thanks guys, ill take it off and hope to not get sprayed lol
Sent from my PC36100 using Tapatalk
-Zach