Keep them in the community tank
Move them to 27g breeding tank
Mauro,
Hold off on water change and feed very sparingly until the eggs hatch. Once the fry hatch do a small water change but try not to disturb the side that the pair is one when draining and refilling, then put the divider in. I find once there are fry to tend the pair will handle changes easier.
Mark
Mauro,
20% WC is good enough once the fry hatch and every 3 days is a good schedule from here out until you remove the fry to a growout tank. The water change and divider should go in before the fry are swimming.
Mark
Happy for you Mauro. You must be walking on clouds.
Your discus are talking to you....are you listening
Hmm, so I see a trend developing? I show up and peoples wilds get busy, lol.
President - North American Discus Association
Congrats Mauro
Len
Watch out guys, Keith is stealing everyone's thunder and taking credit for all the wilds breeding
Your discus are talking to you....are you listening
I don't know Pat. He does seem to have some kind of hocus pocus juju going on. Everytime he asked about mine, they laid again.
Len
Keep visting my posts, Keith. I like that
Thank you.
Hoping that eggs will hatch, I am trying to learn as much as I can about fry development and care requirements. I found David Rose's thread about breeding timeline very useful (http://forum.simplydiscus.com/showth...eding-Timeline).
One of issues I will have to deal with is the possibility of having the fry sucked by the intake of the canister filter. As the video shows, the breeding cone is quite close to the filter's intake, which is covered by a pre-filter sponge. David's thread recommends covering the pre-filter sponge with a nylon (such as ladies nylon) or with a fine micron media bag, secured by a rubber band. I think I wil use the second option. Any takes?
I have absolutely no clue how to hatch brine shrimp. A lot to learn if this breeding experience goes well.
Mauro, use a nice piece of foam to cover or slide over the filter inlet. I would suggest moving the filter input out of the brooding chamber if possible.
I used foam to cover the inlets on my overflow and it works beautifully.
Your discus are talking to you....are you listening
Yes, the foam over the inlet helps to spread the flow over a larger surface area and should reduce the flow in one spot therefore allowing the fry to escape the suction if they get too close.
Your discus are talking to you....are you listening
There are a lot of good threads on hatching bbs, here's a link to my favorite. http://forum.simplydiscus.com/showth...ink#post566827 I use a turkey baster rather than siphoning when you get to that part of the instructions, Martha does now too.
President - North American Discus Association
President - North American Discus Association