tlum
11-13-2004, 01:46 PM
I bought some PraziPro powder from Jehmco. The direction come with the ProziPro is: 1 teaspoon per 20 gallons of water. This will give a concentration of 2.5mg/L of the active ingredient in treated water. I did some calculations and found that it would be converted it to about 95mg per 10 gallons of the active ingreadient, which is very similar to the recommended dosage from this forum - 100mg/10 gallons. However, the direction also suggests re-dose the water on a daily base with partial water change and treat for 5-7days. I read from this forum that this is not necessary. I only need to re-dose it after 7 days (with two partial water change) and continue for a total of 3 treatments. However, also also read from this forum that 2 treatments is sufficient, instead of 3. My goals is to clean all worms and gill fluke before I start breeding my discus. Here are my questions:
1. Should I follow the treatment suggested in this forum (2 or 3 treatments total, 7 days apart, partial water change after 48 hours) instead of the direction come with the Prazi (daily re-dose for 5 to 7 days, partial water change each day).
2. If I follow the suggested treatment in this forum, do I need two treatments or 3 treatments total? All my tanks are BB.
thanks a lot.
Terry
1. Should I follow the treatment suggested in this forum (2 or 3 treatments total, 7 days apart, partial water change after 48 hours) instead of the direction come with the Prazi (daily re-dose for 5 to 7 days, partial water change each day).
2. If I follow the suggested treatment in this forum, do I need two treatments or 3 treatments total? All my tanks are BB.
thanks a lot.
Terry