dvc_r
08-27-2009, 11:02 PM
I had a 50 gal storage tank of RO water. I kept a heater in it until one day my wife emptied the water too much and the heater leaned against the tank, melted it and made a hole in the tank!
Someone suggested a piece of marble tile on the bottom of the (new) tank so I can suction cup the heater to tile to solve my problem. (It worked..sort of).
My question: Is the marble raising up my PH? It used to be around 6.6-6.8, but today it is up to 7.2. The tile is only 8 by 11 inches, do you think this is the problem, or maybe a better question, do you think the ph will continue to go up? If it stays at 7.2 will this be ok for a planted community tank?
Someone suggested a piece of marble tile on the bottom of the (new) tank so I can suction cup the heater to tile to solve my problem. (It worked..sort of).
My question: Is the marble raising up my PH? It used to be around 6.6-6.8, but today it is up to 7.2. The tile is only 8 by 11 inches, do you think this is the problem, or maybe a better question, do you think the ph will continue to go up? If it stays at 7.2 will this be ok for a planted community tank?