Dkarc@Aol.com
03-28-2010, 06:44 PM
Dont worry, im not getting out of the hobby!! Im needing to sell my 300 gallon system ASAP. Everyone's focus in my house as of late is my mom's 14g reef nano....so we made a decision to go full bore and sell the 300gal system and get her (everyone) a 150g cube reef system done right. Cant keep both, so the 300g has to go. Specs:
300 gallon glass aquarium (96"x24"x30") made by Glass Cages.
Reef Ready Overflows built in.
Single 1" bulkhead drilled into back wall of tank at the 50% mark for easy water changes :).
1K Watt heater system with digital controller (2-500W heaters on 1 controller).
Two (2) Iwaki 40RLXT circulation pumps.
Custom built acrylic sump (3/8" thick), made/designed by me.
Filter socks for mechanical filtration
Custom Moving Bed Bio Reactor for Biological filtration (throw any load at it).
Medo Linear Piston Air Pump to provide air to Bio Reactor as well as an airstone into the main display.
One (1) 48" 4 bulb T-5 lighting system (Nova I believe). I know not enough light but it does it's job....kinda.
Ok, the cabinetry....This is where the system kinda shows it's flaws. It is not professionally done, it is far from perfect (looks good from a distance). Dark cherry stain over oak woodwork. The stand itself is made from 4x4 up rights and 2x4 runners. The front of the stand has oak (cherry stained) cabinet doors skinned on front (not professional job). The 2 side cabinets are also oak (cherry stained). Again, the woodwork is not professionally done but is borderline acceptable in my mind to qualify as a "show tank".
System comes with large driftwood, sand, rock, even fish (no discus).
I will do my best to get pictures of the system online ASAP.
Looking to get $2,000 OBO. Located in Clermont, FL....just outside Orlando. Call for more details: 407-765-4890.
-Ryan
300 gallon glass aquarium (96"x24"x30") made by Glass Cages.
Reef Ready Overflows built in.
Single 1" bulkhead drilled into back wall of tank at the 50% mark for easy water changes :).
1K Watt heater system with digital controller (2-500W heaters on 1 controller).
Two (2) Iwaki 40RLXT circulation pumps.
Custom built acrylic sump (3/8" thick), made/designed by me.
Filter socks for mechanical filtration
Custom Moving Bed Bio Reactor for Biological filtration (throw any load at it).
Medo Linear Piston Air Pump to provide air to Bio Reactor as well as an airstone into the main display.
One (1) 48" 4 bulb T-5 lighting system (Nova I believe). I know not enough light but it does it's job....kinda.
Ok, the cabinetry....This is where the system kinda shows it's flaws. It is not professionally done, it is far from perfect (looks good from a distance). Dark cherry stain over oak woodwork. The stand itself is made from 4x4 up rights and 2x4 runners. The front of the stand has oak (cherry stained) cabinet doors skinned on front (not professional job). The 2 side cabinets are also oak (cherry stained). Again, the woodwork is not professionally done but is borderline acceptable in my mind to qualify as a "show tank".
System comes with large driftwood, sand, rock, even fish (no discus).
I will do my best to get pictures of the system online ASAP.
Looking to get $2,000 OBO. Located in Clermont, FL....just outside Orlando. Call for more details: 407-765-4890.
-Ryan